Fan timer with selectable delay and run-on times plus WiFi control; stop the fan at any time by switching the light or by Alexa voice or app commands.
Details
At last you can have complete control of the loo, bathroom or shower room extractor fan.
Using just the light switch or Alexa commands, you can choose whether the fan runs or not.
Light Switch on: the fan starts after 45 seconds and remains on for 15 minutes after the light switch goes off … just like a fan with a run-on timer.
But here is the difference – you can stop the fan at any time – just make a quick on-off or off-on. You can even cancel the 45 second delay if you want the fan on immediately.
A self adhesive light switch sticker "switch twice for fan control" is included with each unit.
In addition, use Alexa app or voice commands to turn the fan on or off. You don’t need an additional hub – the Fan Select connects directly via WiFi to Alexa. The fan will stay running for 15 minutes after the last light switching or Alexa ON command.
Save money on a new installation as the fan doesn't need to have a built-in run-on timer - the Atoko Fan Select does all the work.
If you are adding to an existing installation, you don't need to replace your existing switch or fan or disturb the wiring in the bathroom. Install the Fan Select in the ceiling void/loft. You can even fit the controller if your existing fan has built-in run-on; the run-on time will be the shorter of the built in time and 15 minutes.
If you don't like the fan coming on every time you switch on the light (and where regulations permit), you can set it to only come on when selected either by light switch or Alexa command .
If you don't like the default delay time (45 secs) or run-on time (15 minutes), you can even adjust those.
[Note: If the fan has built-in run-on and this is set to less 15 minutes, then the fan will only run on for that length of time after the light switch is turned off. Any fan built-in delay turn-on feature should be disabled - refer to the fan manufacturers instructions for appropriate switch/jumper settings].
Specification
+ Each screw terminal accepts 2 x 1.5 mm2 wires
+ Maximum load 2200W/10A resistive
+ For indoor use only
+ Must not be used in wet areas; that is where water or other liquids could come into contact with the device.
+ Should be installed in loft space, ceiling cavity or similar where specific deliberate access to its location would be necessary.
+ Must not be used where damage, injury or losses could occur if the device failed to operate as expected.
